100 FT 12/2 UF-B W/GROUND UNDERGROUND FEEDER DIRECT BURIAL WIRE/CABLE
UF-B cable may be used underground, including direct burial. Multiple conductor UF-B cable may be used for interior branch circuit wiring in residential or agricultural buildings at conductor temperatures not to exceed 90°C (with ampacity limited to that for 60°C conductors) as specified by the National Electrical Code.
2.0mm Desoldering Braid Solder Sucker Remover Spool Copper Wick 5 ft 1.5m
1 Roll Copper Solder Wick Desoldering Braid 2mm Wide with. – Desoldering braid (wick) is a copper braid used in the rework and repair of printed. – 2 x Desoldering Braid. – This wick is made from oxygen free copper.
3 PCS. – Durable 1.5M x 2.0 mm Copper Braid Desoldering Solder Removal Wick
Okay ….. we did it again. We bought waaaaaaay too many of these premium desoldering wick spools. We always have 2 or 3 on each bench, but the boss says we STILL have too many so…….. GET RID OF ‘EM!!!! IN STOCK…IN THE GOOD ‘OLE USA. BE CAREFUL!! There are some unscrupulous sellers using a picture that shows1.5M (~5 ft.) length, when in reality the length is only HALF that(75 cm or ~ 2.5 ft.) READ THE FINE PRINT IN THEIR DESCRIPTIONThese are a FULL 1.5M long3 PIECES PER ORDER*** FREE SHIPPING *** We are very “picky” about which fluxes we permit within our facilities. To avoid quality problems from cross-mixing fluxes the solder wick cannot be heavily “pre-fluxed”. By using solder wick that is unfluxed, our technicians can use our Kester 186-18 (or similar) flux along with this un-fluxed wick. No worry of mixing fluxes. This is EXTREMELY important in PCB Rework.Mixing “water soluble” fluxes with the more traditional, established rosin/resin-based fluxes can cause “white residue” build-up and prevent quality soldering between pads and chip leads. This is only one of many reasons for our use of “un-fluxed wick” at the bench of our technicians, engineers and quality personnel.Specifications:Condition: NewMaterial: Copper Length: 1.5mWidth: 2.0mmShape: CircleWeight: 7gPackage Size: ~50mm*50mm*10mmUnfluxed for greater versatility and contamination avoidanceEach spool individually packaged and sealedQuantity: 3 pieces *** GREAT TIP *** For proper solder removal – use a bit of melted solder or liquid flux (preferred) on the exposed solder wick braid just prior to heating the old solder joint. (We also offer flux gel, liquid Kester 186-18 solder flux in a squeeze bottle or a refillable pen dispenser.) A word about …Shipping during the Virus Pandemic We are not quite sure from where or how eBay gets its estimated shipment receipt date, but it seems to be varying from days to weeks for the same item!!! Here’s our policy on shipments and orders….. We strive to ship every order within 1 business day (we do NOT ship on weekends).We use (primarily) USPS 1st Class postage service with tracking. USPS does a GREAT job of handling our thousands of packages. They have a few glitches now and then but overall they provide excellent service. Note that we are not privy to USPS tracking information beyond what you can retrieve via eBay or USPS. If you have ANY questions about your purchase, parcel logistics, etc. please feel free to either send us (using your eBay account) an email detailing the problem OR file a formal request with eBay. We ALWAYS respond to such cases in a positive supportive manner. FEEDBACK Leaving neutral or negative feedback without an attempt to communicate your concern or complaint does nothing to solve your problem. If you are voicing a problem through feedback, we only learn of your dissatisfaction well after the problem has occurred without an opportunity to make the matter right. If you have a problem with the product or an inquiry on the delivery of your order, ASK US!!! Give us a chance to make it right. We are here to make your buying experience a fast, efficient, cost-effective, and pleasant experience. STANDARD DISCLAIMER This Ebay Account Holder is furnishing this item “as is”. We do not provide any warranty of the item whatsoever, whether express, implied, or statutory, including, but not limited to, any warranty of merchantability or fitness for a particular purpose or any warranty that the contents of the item will be error-free. In no respect shall we incur any liability for any damages, including, but limited to, direct, indirect, special, or consequential damages arising out of, resulting from, or any way connected to the use of the item, whether or not based upon warranty, contract, tort, or otherwise; whether or not injury was sustained by persons or property or otherwise; and whether or not loss was sustained from, or arose out of, the results of, the item, or any services that may be provided by this Ebay account. If a recognizable item appears in this account, use for commercial purposes may infringe a right of privacy or publicity. It may not be used to state or imply the endorsement by this Ebay account holder of a commercial product, process or service, or used in any other manner that might mislead. Accordingly, it is requested that if this account is used in advertising and other commercial promotion, layout and copy be submitted to this Ebay Account Holder prior to release. It may not be used to state or imply the endorsement by this Ebay Account Holder of a commercial product, process or service, or used in any other manner that might mislead.For industrial, hobbyist or experimental use only. We cannot offer advice on a specific application. Buyer should be aware of all necessary federal, state and local safety precautions that may be needed for the proper safe use of the purchased item. Any warranties are limited to replacement of product or refund of purchase price.
10 PCS. – Durable 1.5M x 2.0 mm Copper Braid Desoldering Solder Removal Wick
Okay ….. we did it again. We bought waaaaaaay too many of these premium desoldering wick coils. We always have 2 or 3 on each bench, but the boss says we STILL have too many so…….. GET RID OF ‘EM!!!!IN STOCK…IN THE GOOD ‘OLE USA. BE CAREFUL!! There are some unscrupulous sellers using a picture that shows1.5M (~5 ft.) length, when in reality the length is only HALF that(75 cm or ~ 2.5 ft.) READ THE FINE PRINT IN THEIR DESCRIPTIONThese are a FULL 1.5M long10 PIECES PER ORDER*** FREE SHIPPING *** We are very “picky” about which fluxes we permit within our facilities. To avoid quality problems from cross-mixing fluxes the solder wick cannot be heavily “pre-fluxed”. By using solder wick that is unfluxed, our technicians can use our Kester 186-18 (or similar) flux along with this un-fluxed wick. No worry of mixing fluxes. This is EXTREMELY important in PCB Rework.Mixing “water soluble” fluxes with the more traditional, established rosin/resin-based fluxes can cause “white residue” build-up and prevent quality soldering between pads and chip leads. This is only one of many reasons for our use of “un-fluxed wick” at the bench of our technicians, engineers and quality personnel.Specifications:Condition: NewMaterial: Copper Length: 1.5mWidth: 2.0mmShape: CircleWeight: 7gPackage Size: ~50mm*50mm*10mmUnfluxed for greater versatility and contamination avoidanceEach spool individually packaged and sealedQuantity: 10 pieces *** GREAT TIP *** For proper solder removal – use a bit of melted solder or liquid flux (preferred) on the exposed solder wick braid just prior to heating the old solder joint. (We also offer flux gel, liquid Kester 186-18 solder flux in a squeeze bottle or a refillable pen dispenser.) A word about …Shipping during the Virus Pandemic We are not quite sure from where or how eBay gets its estimated shipment receipt date, but it seems to be varying from days to weeks for the same item!!! Here’s our policy on shipments and orders….. We strive to ship every order within 1 business day (we do NOT ship on weekends).We use (primarily) USPS 1st Class postage service with tracking. USPS does a GREAT job of handling our thousands of packages. They have a few glitches now and then but overall they provide excellent service. Note that we are not privy to USPS tracking information beyond what you can retrieve via eBay or USPS. If you have ANY questions about your purchase, parcel logistics, etc. please feel free to either send us (using your eBay account) an email detailing the problem OR file a formal request with eBay. We ALWAYS respond to such cases in a positive supportive manner. FEEDBACK Leaving neutral or negative feedback without an attempt to communicate your concern or complaint does nothing to solve your problem. If you are voicing a problem through feedback, we only learn of your dissatisfaction well after the problem has occurred without an opportunity to make the matter right. If you have a problem with the product or an inquiry on the delivery of your order, ASK US!!! Give us a chance to make it right. We are here to make your buying experience a fast, efficient, cost-effective, and pleasant experience. STANDARD DISCLAIMER This Ebay Account Holder is furnishing this item “as is”. We do not provide any warranty of the item whatsoever, whether express, implied, or statutory, including, but not limited to, any warranty of merchantability or fitness for a particular purpose or any warranty that the contents of the item will be error-free. In no respect shall we incur any liability for any damages, including, but limited to, direct, indirect, special, or consequential damages arising out of, resulting from, or any way connected to the use of the item, whether or not based upon warranty, contract, tort, or otherwise; whether or not injury was sustained by persons or property or otherwise; and whether or not loss was sustained from, or arose out of, the results of, the item, or any services that may be provided by this Ebay account. If a recognizable item appears in this account, use for commercial purposes may infringe a right of privacy or publicity. It may not be used to state or imply the endorsement by this Ebay account holder of a commercial product, process or service, or used in any other manner that might mislead. Accordingly, it is requested that if this account is used in advertising and other commercial promotion, layout and copy be submitted to this Ebay Account Holder prior to release. It may not be used to state or imply the endorsement by this Ebay Account Holder of a commercial product, process or service, or used in any other manner that might mislead.For industrial, hobbyist or experimental use only. We cannot offer advice on a specific application. Buyer should be aware of all necessary federal, state and local safety precautions that may be needed for the proper safe use of the purchased item. Any warranties are limited to replacement of product or refund of purchase price.
Danfoss Micro Plate Carrier Chiller Heat Exchanger C12L 3″x6″
Danfoss Micro Plate Carrier Chiller Heat Exchanger C12L 3″x6″ Danfoss Heat Exchanger Part: C12L-EZ-R-20 Carrier Part: LS50ZJ001 Test Pressure 49 bar Surface Area .18 m2 Material of Plate 316L Pure Brazing Copper T2 If there’s something you’re not sure about or have a question about anything, just send us a message by clicking “Ask a question” below the listing. Free Shipping is only for the inner 48 states (Large Freight Shipments Do Not Apply). ,
(20) total 5-ft 150cm Charging Cable 120A Battery quick disconnect harness #6
Here are (20) total, 5 foot long, #6 AWG cable assembly harnesses, with (1) SB120 120 amp quick disconnect connectors on each end. The cables in each set are further contained within a shrink wrap sheath for extra protection. Connectors are Tyco Electronics 120 amp rated, 600 volt rated. This is a military MIL spec harness.