SOUTH BEND 10L BRONZE BEARING UNDER MOUNT HEAVY 10 LAMINATED BRASS LATHE SHIMS
DON'T WAIT GET THEM WHILE THEY ARE IN STOCK AFTER THESE SELL IT MIGHT BE WEEKS TILL THE NEXT BATCH BECOME AVAILABLE SOUTH BEND HEAVY 10 TEN LAMINATED BRASS SHIMS ONLY DIE CUT MADE IN U.S.A. AMERICA THESE ARE LAMINATED BRASS SHIMS ONLY FOR HEAVY (10) TEN SOUTH BEND LATHE BRONZE BEARING TYPE. THE LAMINATION'S ARE (1) LAYER .001, (15) LAYERS .002 BRASS TOTAL THICKNESS IS .031 +/- .001. I MADE THESE BECAUSE I SAW THE QUALITY OF THE ORIGINALS AND THOUGHT THAT THEY COULD USE SOME IMPROVEMENT. MADE BETTER THAN THE ORIGINALS, THEY TAKE INTO ACCOUNT THE MISALIGNMENT OF THE FACTORY HAND DRILLED SCREW HOLE AND DOWEL PIN LOCATOR. MADE IN THE U.S.A. BY ME IN MY HOME MACHINE SHOP. EACH SET INCLUDES (2) FRONT LAMINATED SHIMS AND (2) REAR LAMINATED SHIMS
SOUTH BEND 10L HEAVY 10 LATHE REPLACEMENT THRUST WASHER
Made in U.S.A.SOUTH BEND HEAVY 10 (10L) REPLACEMENT THRUST WASHER. This unit will replace a steel or fiber thrust washer for any South Bend Heavy 10. These units are made of .125 thick (1/8) Impregnated Oil-light Bronze giving a far superior bearing surface over stock units. oil-light Bronze is a porous material that traps oil and distributes it evenly over its entire surface. You get the best solution to a common problem. I not only make these from scratch in my home shop, I used the first prototype on my heavy 10 after noticing excessive wear, and I am a believer. Unit comes ready to use with indexing pin installed. Posted with eBay Mobile